
Alarm - Paralyser D4800
Factory Immobiliser Upgrade
FEATURES
- Upgrades any keyless entry system into a full alarm system.
- Uses vehicles OEM supplied remote controls.
- Requires basically only 3 connections for the identification of arm/disarm.
- Two trigger inputs- for doors and bonnet and or boot.
- Milli volt sensing- (installer selectable)
- User retrievable diagnostics - reports the last three triggers in reverse order.
- Automatic fault isolation - should a zone become defective, the D4800 will isolate and ignore the circuit responsible.
- Intelligent siren reset timer- meets AS/NZS 3749.1-1997
- Output to drive either horn or siren
- False alarm free glass breakage detector- (plug in)
- Pulsed or constant output- (Installer selectable)
- Two circuits of built in immobilization
- Indicator lights confirmation flash outputs- (2 On, 1 Off)
- Confirmation flashes- (installer removable).
- Confirmation siren/horn beeps- (Installer removable).
- Bright red flashing LED warning light.
- Operating voltage- +9VDC - +18VDC.
- Operating ambient temperature - 300 C to + 50 C
- Operating current- < 15 mA.
- Operating field strength environment -Up to 50 V/M (1 MHz to 1000 MHz)
- Load dump protected (70 Joules)
- Polarity independent
- Options:
- Plug in ultrasonic or microwave detectors.
- The D4800 is Certified to AS/NZS 3749.1-1997 Intruder Alarm Systems Road Vehicles.
- As detailed in Test report EMC 000501.00 (Issued May 2000) Certificate No. 501.03
- Note the d4800 will only qualify in respect to as/nzs 3749.1:1999 provided that the remote control supplied by the vehicle manufacturer has rolling code and the vehicle is equipped with Automatic engine immobilisation as fitted by the manufacturer.