
Immobilisers - Paralyser
D3400

FEATURES
Two circuit engine immobiliser - 40amp relays built in.
Remote controlled - code hopping system with 1,800,000,000,000,000,000 code combinations.
Hazard lights flash- for confirmation of arm/disarm.
All black wiring for security.
Auto IMMOBILISING - 39 seconds after ignition turn off.
Independent hazard fuse - main unit does not loose power if thief short circuits an indicator.
Concealed plug in assembly - unit can not simply be unplugged.
Override PIN code- is entered by means of ignition switch.
Bright flashing LED - indicates status of immobiliser.
Hot wire warning - hazard lights flash for 5 seconds.
Optional door, bonnet or boot protection - horn sounds if any are opened.
Central locking outputs - able to directly drive alternative negative triggered central locking.
Optional boot release - output available to activate release boot relay.
Panic mode - engage horn by remote control.
Optional door re-lock function - re-arm & re-lock doors if disarmed and door not opened.
High current negative output for interior light - drives resistive loads up to 2amps.
Wide band operating voltage - 9 volts to 18 volts
Extra low operating current - less than 10 mA in the armed mode.
Reverse polarity protected.
Load dump protected.
Fail safe immobilisation circuitry - if system looses +12 volts or one ground while driving, engine continues running.
Normally open immobilisation relay contacts - ensuring that engine cannot be started if power removed to system while armed.
Physical dimensions :- 96 mm x 70 mm x 42 mm